HOT ! Ebac AM2000 Air Mover – 1060 CFM, 550W, 4 Positions, 26.4 lbs

Ebac AM2000 Air Mover – 1060 CFM, 4-Position, 26.4 lbs

The Ebac AM2000 is a centrifugal air mover rated at 1060 CFM at 550W and 5A on a standard 110V circuit. It weighs 26.4 lbs with a roto-molded polyethylene housing and adjusts to four airflow positions — 0°, 15°, 45°, and 90° — without tools. At 52 dBA it is quiet enough for occupied spaces, making it a flexible choice for water damage drying jobs, commercial floor maintenance, and general-purpose air circulation.

Airflow and Positioning

• 
  Airflow: 1060 CFM — sufficient for drying flooring, wall cavities, and open floor areas in residential and commercial settings.


• 
  4 airflow positions: 0°, 15°, 45°, 90° — angle changes without tools to direct airflow at floors, walls, or ceilings.


• 
  3 operating speeds — match airflow to the job requirement and reduce energy draw during maintenance drying.


• 
  Power: 550W / 5A — fits any standard 15A circuit; multiple units can run from a single 20A circuit.


• 
  Weight: 26.4 lbs — roto-molded polyethylene housing resists impact during transport between jobs.


• 
  Noise: 52 dBA — low enough for occupied residential and light commercial environments.

Water Damage Drying and General Use

The AM2000 works across structural drying, carpet drying, hardwood floor drying, and general ventilation tasks. At 0° the airflow runs across the floor surface, pulling moisture from carpet padding and subfloor edges. At 45° it reaches behind baseboards and into wall cavities without removing trim. At 90° it provides vertical column airflow for ceiling tile drying or directed ventilation. The polyethylene housing does not corrode or absorb water, and the low 5A draw allows crews to run four to five units per 20A circuit without tripping breakers during overnight drying cycles.

Stackability and Transport

The AM2000 stacks for van or truck transport. The integrated handle makes one-hand carry practical at 26.4 lbs. Roto-molded construction is resistant to cracking from stacking pressure or job-site impact, reducing replacement costs compared to ABS units in the same weight class. The 52 dBA operating noise level is lower than most competitors at this CFM rating, making it feasible to deploy in hotels, schools, and healthcare facilities where noise is a factor.

Specifications

Documents

Spec Sheet

Manual